12/26/2005 6:04:28 PM
|
changing my configuation and pump usage on my aquarium. I have three 1" savko bulkheads set up in a triangle about 6 inches apart. I need to connect them all to one 1 1/2 inch pipe that runs parallel to the tank. How best to achieve this with minimal friction loss.
I also then need to run that as a feed and exit the pump with a 1 1/2" pipe that splits into three 1 inch lines.
I was running three pumps and want to run one pump with a much higher capacity. Mainly to save electricity but I need more flow and the sequence 3200 SW pump provides me that capability. I hope so, already bought the pump.
thanks for the ideas. |